Marine High Protective Coatings Top Coats

ROXY

Sea Guard Coal Tar Epoxy

This is a two pack high performance top coat Based on Epoxy resin blended with special coal tar. Chemical resistance and Saline water resistance of Epoxy Resin makes this coating highly saline waterproof top coat. Its excellent resistance to saline water properties are ideal for marine environment.

AREA OF APPLICATION:

It is used on all iron & steel, concrete and wooden surfaces of all river or sea-going vessels, pontoons, sea-shore structures etc.

SHADE:

Black

TECHNICAL INFORMATION:

Viscosity

Thick viscous liquid

Gloss

Glossy

Mixing Ratio

Base : C/A = 2:1 by volume

Pot Life (After mixing)

6 hrs approx.

Thinner

Roxy Epoxy Thinner

Thinning ratio

10-15 %

Coverage

250 - 270 sft / 4 liters. On non absorbent surface

Recommended DFT

75 - 85 microns / coat

Flash point

Below 70º F

DRYING TIME:

Surface dry:1 - 1.5 hrs
Hard dry:10 – 12 hrs
Recoating time:After 12 hrs
Full Cure:7 days

Shelf Life

One year in sealed container when kept in cool and dry place.

Pack Size

4 Ltr, 20 Ltr

SURFACE PREPARATION

The surface must be properly cleaned and free from rust, old paints, grease, wax, salt deposit or other contaminants. Repair surface defects before painting.

APPLICATION METHOD

Always stir paint properly before use. Mix paint with Curing Agent (Hardener) at 2:1 ratio by volume. Apply by brush or roller after thinning 8-10% by vol. with Roxy Epoxy Thinner. Mixed paint must be used off with in 6 hrs approximately. Apply 2 coats of this finish paint Check proper drying before next coat. This paint can be applied by spray after proper thinning.

The information given herein is to the best of our knowledge accurate and is believed to be reliable. We do not take any responsibility since the conditions of use are beyond of our control. For further information please contact our sales center nearest to you.