Marine High Protective Coatings Undercoats

ROXY

Sea Guard Epoxy Red Oxide Primer

This is a two pack high performance primer Based on Epoxy resin, Red Oxide pigment & stable Extenders. Chemically inert property of Red Oxide pigment and Saline water resistance of Epoxy Resin makes this coating ideal for iron and steel surfaces as primer coat. Its excellent resistance to saline water properties make it suitable for marine environment.

AREA OF APPLICATION:

It is used on all iron and steel surfaces of all river or sea-going vessels, pontoons, sea-shore structures etc.

SHADE:

Self Brown color of Red Oxide Pigment

TECHNICAL INFORMATION:

Viscosity

100 - 110 seconds/BSB4/30ºC

Gloss

Eggshell with higher sheen

Mixing Ratio

Base : C/A = 2:1 by volume

Pot Life (After mixing)

6 hrs approx.

Thinner

Roxy Epoxy Thinner

Thinning ratio

10-15 %

Coverage

475-500 sft / 4 liters. On non absorbent surface

Recommended DFT

40- 45 microns / coat

Flash point

Below 70º F

DRYING TIME:

Surface dry:45 - 60 minutes
Hard dry:10 – 12 hrs
Recoating time:After 12 hrs
Full Cure:7 days

Shelf Life

One year in sealed container when kept in cool and dry place.

Pack Size

4 Ltr, 20 Ltr

SURFACE PREPARATION

The surface must be properly cleaned and free from rust, old paints, grease, wax, salt deposit or other contaminants. Repair surface defects before painting.

APPLICATION METHOD

Always stir paint properly before use. Mix paint with Curing Agent (Hardener) at 2:1 ratio by volume. Apply by brush or roller after thinning 10-15% by vol. with Roxy Epoxy Thinner. Mixed paint must be used off with in 6 hrs approximately. Apply 1-2 coats of this Primer Check proper drying before next coat. This paint can be applied by spray after proper thinning.

The information given herein is to the best of our knowledge accurate and is believed to be reliable. We do not take any responsibility since the conditions of use are beyond of our control. For further information please contact our sales center nearest to you.